Pneumatic cylinder slow or weak: where do you look first?

0 replies · 5 views

  1. Controls Trainer Staff

    Common causes, roughly in the order we'd check them:

    • Low supply pressure. Check the gauge at the machine, not just at the compressor.
    • Clogged filter in the FRL, or a regulator set low.
    • Flow controls turned in too far. Most are set meter-out, so check the one on the exhaust side.
    • Leaking piston seals. With the cylinder pushed to the end of its stroke, air blowing out the opposite port is a giveaway.
    • Kinked or undersized tubing, or a quick-connect that's half blocked.
    • A valve that's sticking or not shifting all the way.

    Before you open anything up: dump the air and make sure it stays dumped. A cylinder that's still holding pressure can move when you loosen a fitting. Stored air is part of your lockout.

    What did we miss?

Reply

Log in or create a free account to reply. It's free and comes with Levels 1 and 2.

← More in Maintenance & Mechanical

Your next challenge · free to start

Put your skills to work.

Wire a motor starter in Level 1 or troubleshoot a stopped conveyor in Level 2. No account needed to start.

30-day giveaway: Pass both levels on your account to earn all 10 levels free for 30 days. Once per person.

Try Level 1 free →Try Level 2 free →