V-belt tension: how do you check it on the floor?

0 replies · 6 views

  1. Controls Trainer Staff

    The common quick check is deflection: press on the middle of the span and look for about 1/64 inch of deflection per inch of span. On a 32 inch span that's about 1/2 inch. The belt maker's chart gives the force to push with.

    A sonic tension meter takes the guesswork out if your shop has one.

    A few things that matter as much as tension:
    - Sheave alignment. A straightedge or laser across both faces.
    - Worn sheaves. Grooves that are dished out will eat new belts.
    - New belts stretch. Re-check tension after the first day of running.
    - Matched sets on multi-belt drives. Don't replace just one.

    Lock out the drive before you put a hand near it, even "just to check."

    How do you do it at your plant?

Reply

Log in or create a free account to reply. It's free and comes with Levels 1 and 2.

← More in Maintenance & Mechanical

Your next challenge · free to start

Put your skills to work.

Wire a motor starter in Level 1 or troubleshoot a stopped conveyor in Level 2. No account needed to start.

30-day giveaway: Pass both levels on your account to earn all 10 levels free for 30 days. Once per person.

Try Level 1 free →Try Level 2 free →