SPECIFIC REQUIREMENTS · ACTUAL LESSON ACTIONS For manufacturing safety teams, Controls Trainer connects specific safety requirements to actions employees can practice. Here are five examples from the actual lessons. 29 CFR 1910.333(b)(2)(ii)(B) and (iii)(A) OSHA nineteen ten point three three three requires electrical isolation, with locks and tags on the disconnecting means. A Stop button is not a substitute. 29 CFR 1910.333(b)(2)(iii)(A) and (iv)(B) In Level One, the learner opens the main disconnect and applies a personal lock and tag. Wiring stays locked until the lesson's electrical safety checks are complete. NFPA 70E (2024), 120.6(7) NFPA seventy E, twenty twenty-four, section one twenty point six, step seven, calls for testing at each point of work and verifying the tester before and after. NFPA 70E (2024), 120.6(7) · 29 CFR 1910.333(b)(2)(iv)(B) Our electrical lessons teach that sequence with a simulated meter. Prove it on a known source, test the required circuit points, then prove it again. The incoming line side can still be live. 29 CFR 1910.147(d)(5)(i) and (d)(6) OSHA nineteen ten point one four seven requires hazardous stored energy to be controlled and isolation verified before servicing. 29 CFR 1910.147(d)(5)(i) and (d)(6) In Level Five, learners support the vertical axis, secure the part, isolate the air, and check the downstream pressures. Electrical power off does not remove pneumatic or gravity hazards. 29 CFR 1910.303(b)(3) OSHA nineteen ten point three zero three requires completed wiring to be free of unintended shorts and grounds. Level One teaches circuit connections through labeled terminals, with checks against the required wiring. 29 CFR 1910.212(a)(1) OSHA nineteen ten point two one two requires protection from machine hazards. Level Ten asks learners to identify hazards and select suitable safeguards. 29 CFR 1910.212(a)(1) · Guard-function training example In Level Six, they can open the simulated guard and observe the machine stop. They then practice restoring the guard and resetting the safety circuit before a deliberate restart. controlstrainer.com/compliance.php Specific requirements. Repetitive safety practice. Use Controls Trainer alongside your plant procedures and practical evaluation. Explore the lessons and cited references at Controls Trainer dot com slash compliance.